Daikin Brc4c160 Manual ((hot)) Jun 2026

button once. The left digit on the screen will begin to blink. Scroll the Codes : Press the

The BRC4C160 allows you to toggle through several modes using the Operation Mode Selector Lowers the room temperature to your setpoint.

In this article, we will provide a deep dive into everything covered in the official manual. From initial installation to advanced timer settings and error codes, consider this your complete guide to mastering the BRC4C160.

When the louvers reach your desired angle, press the button again to lock them in place. Setting the Timer

: Toggle between High or Low settings using the fan speed control button. Daikin Brc4c160 Manual

Press and hold the "Timer" and "Cancel" buttons simultaneously for 5 seconds. Use the up/down arrows to switch between °C and °F. Press "OK" to save.

First, check the circuit breaker for the indoor unit. Next, verify the low-voltage wiring is not damaged. If there is 12-24 VDC across P1-P2, the controller may have failed. If there is no voltage, the indoor unit’s control board may be faulty.

What is the of your indoor unit (e.g., FXFQ, FXAQ)?

The BRC4C160 allows you to tailor your climate across five distinct operating modes. Fan Only Mode button once

When the "Filter" icon appears, it means the unit has accumulated 2,500 operating hours. After cleaning the air filter, press the "Filter" button for 2 seconds (or use the combination in the manual) to reset the timer.

Note the two-character code (e.g., A6, E3, U4) and contact a certified Daikin technician. Common Troubleshooting Scenarios

While end-users can replace a remote, the installation and initial setup of a Daikin HVAC system must be performed by a certified professional.

: If the controller is unresponsive, press and hold the ON/OFF button for 5 seconds until the screen goes blank, then restart. In this article, we will provide a deep

The installation section of the manual is strictly for qualified technicians. Incorrect wiring can destroy the controller’s PCB.

Press the button again to make the second digit flash. Use the Temperature Adjustment buttons to scroll until you hear another sustained, long beep.

For the most accurate and detailed information, consulting the official Daikin documentation is always best. Fortunately, these resources are readily available: