Mount the main control module deep inside the dashboard. Avoid areas near heating ducts or moving parts (like the steering column or wiper linkages).
The Cobra 3195 uses the dashboard LED to diagnose triggered events or faults. When you disarm the system, observe the LED pattern:
To help me tailor any specific technical details for your vehicle setup, tell me:
Press the small button (often "B") on the remote. Indicators flash once, the LED turns off, and doors unlock.
Press both buttons on the new remote control until the LED on the remote stops flashing, then release. Ensure the remote LED lights up in fixed mode. 4. Installation and Wiring Guidelines cobra 3195 alarm manual full
Press both buttons on the new remote control simultaneously until the remote's internal LED stops flashing and stays on (about 10 seconds). Release both buttons. The remote LED will light up solid.
Monitors doors, boot (trunk), and bonnet (hood) via direct pin switches or the vehicle's CAN-bus/original wiring.
Turn the ignition OFF . Wait for the LED to flash 2 times , then immediately turn the ignition ON .
Meets strict insurance criteria for electronic alarm and immobilization systems. Mount the main control module deep inside the dashboard
To sync a new remote (requires at least one working remote or the PIN): Disarm the system and open the driver's door and bonnet. Turn ignition .
Turn the ignition and repeat for the remaining three digits.
is designed for high security and flexibility. Key components include:
: Watch the LED. Count the number of flashes until it matches your first digit, then turn the ignition OFF and immediately back ON . When you disarm the system, observe the LED
: Detects air movement inside the cabin caused by broken glass or intrusion.
Press the on the remote once. The vehicle's dashboard LED will turn on for 2 seconds to confirm registration. Repeat steps 5 through 7 for any additional remotes. Turn the ignition OFF to exit programming mode. 5. Wiring Diagram and Installation Specifications
Scenario 3: The siren emits a series of short chirps when arming.
Triggers instantly if the doors, boot, or bonnet are breached.
Within 5 seconds, press the on the remote control.
If your remote control battery dies or the handset is lost, use this manual override to drive the vehicle: