| Error Message | Cause | Windows 10 Fix | | :--- | :--- | :--- | | “The driver is not intended for this platform” | Trying to install 32-bit driver on 64-bit Windows 10 | Use PICPGM’s WinUSB driver. Do not use the CD driver. | | “USB device descriptor failed” | CH340 chip is counterfeit or driver clash | Uninstall all USB drivers under “Universal Serial Bus devices” in Device Manager, then reinstall CH340 driver. | | “Failed to open device. Access denied.” | Another application (like Arduino IDE) has the COM port locked | Close all serial monitor software. Change COM port number in Device Manager to COM1-COM4. | | “PIC not found. MCLR voltage error.” | Incorrect Vpp voltage or poor connection | Windows 10 USB ports provide 5.0V, but some PICs need 13V. Check your K150’s jumper for external power. Ensure target PIC is powered externally (K150 supplies limited current). | | “Verify failed at address 0x0000” | Timing issue due to Windows 10’s USB polling | In PICPGM, increase the “Delay for Vpp” to 50ms. In WinPic800, reduce communication speed to “Low.” |
This is the standard interface. To prevent it from crashing on Windows 10: Right-click the micropro.exe file and select . Go to the Compatibility tab.
: Draws power directly from the PC, requiring no external power supply. Windows 10 Setup Guide k150 pic programmer software windows 10
You need a software bundle that contains both the microPro burning application and an older, compatible version of the Prolific driver.
This guide provides a comprehensive walkthrough on downloading the correct software, installing the necessary drivers, and troubleshooting common USB connection issues on Windows 10. 1. Prerequisites: What You Need To use the K150 programmer, you will need: Windows 10 PC. Microblaze PIC Programmer Software (Microbrn). | Error Message | Cause | Windows 10
You can find the software on Phipps Electronics or various electronics forums that host the Microbrn.exe package.
Click Load and browse for the compiled .hex file you want to program onto the chip. | | “Failed to open device
You have three viable paths to run K150 software on Windows 10: