should be mounted in the steering compartment on a flat surface, typically a platform adjacent to the rudder post.
Inspect the blue and brown wires for breaks, corrosion, or short circuits.
Move the steering wheel to starboard. Look at the rudder angle indicator on your display. If the display shows the rudder moving port instead of starboard, invert the rudder polarity setting in the autopilot menu, or swap the physical mounting geometry. 6. Troubleshooting Common Issues Probable Cause Corrective Action Autopilot shows "No Rudder Response" error Broken wire or bad connection. simrad rf300 installation manual
Are you currently encountering a specific ? Share public link
Perform a final test by verifying that the rudder angle indicator on the screen matches the actual physical position of the rudder. 7. Troubleshooting and Maintenance Common Issues should be mounted in the steering compartment on
The installation process involves careful mechanical linkage and proper electrical wiring. The following steps synthesize the official factory instructions to ensure you avoid the most common mistakes (such as forcing the feedback arm).
: Fasteners for securing the RF300 base to the hull or mounting platform. 2. Tools and Materials Required Look at the rudder angle indicator on your display
Note: If your specific cable includes an uninsulated shield/drain wire, connect it to the chassis ground terminal on the autopilot computer to prevent RF interference. Cable Routing Guidelines