Working with a spec file created in a newer version of CADWorx (e.g., 2022) while using an older version (e.g., 2018) causes schema mismatches, leading to error 6007.
Are you using keys or the Intergraph SmartLicensing (ISL/SPLM) system?
Before editing software configuration files, check your raw network connectivity to rule out basic hardware or IT infrastructure problems. error number 6007 cadworx
If none of the above resolves error 6007, provide the following to (formerly Intergraph):
If all else fails, a complete and clean reinstallation is your most reliable solution. This is the method that has resolved the issue for many users. Working with a spec file created in a
Run the [Link] utility on the server holding the Red NetHASP key.
Based on community reports and technical documentation, this error typically manifests in two ways depending on your version: Physical License Key (Older Versions) If none of the above resolves error 6007,
: CADWorx may prioritize a local hardware lock over a network one. If you have a local lock plugged in that isn't authorized for the module you're trying to use, it may trigger a licensing error.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. HASP Support Guide - Green and Red Network Key - Intergraph
The official error documentation from the software's developer, COADE (now Hexagon), lists the most common reasons a license might not be found:
Locate your nethasp.ini file. This is typically stored in your CADWorx installation directory or the Assidrv utility folder. Open the file using a standard text editor. Find the [NH_TCPIP] section.