Aei Dk 9830 Change: Password Better

Brand new or fully reset units use standard factory codes. You must change these default values immediately during installation to secure the system. 0000 Factory User Code: 1234 (assigned to Slot 1) Step-by-Step: Change the Master Programming Code

). The "Status" LED should flash to indicate you are in programming mode. Select Command (this is the command digit for changing the Master Code). Enter New Code : Type your new 4 to 8-digit to exit programming mode. How to Change a User PIN If you need to update a specific user's door code: Enter Programming Mode followed by the Master Code Select User Slot : Enter the for the first user) followed by the new Critical Tips aei dk 9830 change password

Type your new 4-to-1-digit code (e.g., 4 3 2 1 ). Confirm the Code: Press the * (asterisk) key to save. Exit Programming Mode: Press the # (pound) key. Brand new or fully reset units use standard factory codes

The Green LED will flash to confirm the code length has been updated 1.2.1. 3. What to Do If You Forgot the Master Code The "Status" LED should flash to indicate you

Do not use sequential sequences (1234), repeating digits (1111), or obvious years (2026).

The master code is the key to your system's settings. If you are still using the factory default code, you should change it immediately to prevent unauthorised users from tampering with your security settings. Follow these steps to change the Master Code:

If you inherit a property with an AEI DK-9830 or simply forget your programmed Master Code, you will be locked out of the programming menu. You can perform a hardware reset to restore the factory default Master Code without erasing your existing user codes. Hardware Reset Procedure: Turn off the power supply to the keypad.