A: First, ensure the Reverb knob for the specific channel you are using is turned up. Then, check the master Reverb knob in the main output section. Finally, if you have an external processor connected to the Send/Return jacks, ensure it is properly configured and powered on, or disconnect it to test the unit's internal reverb.
: Connect microphones via XLR or instruments/line sources via 1/4" cables. Adjust the individual channel gain first, then use the Master Level to control the overall volume.
: If the LED doesn't light up, ensure the power adapter is securely connected to both the wall and the receiver. PROFESSIONAL WIRELESS MICROPHONE SYSTEM MANUAL audio choice qm4 manual
: Includes a 3-band Master EQ, Master Reverb, and Master Level controls. Additional Connectivity : EFX Loop : For external effects processing.
Slowly turn up the channel's individual until the signal sounds full but clean. If you hear audible clipping or crackling distortion, back the knob off immediately. A: First, ensure the Reverb knob for the
3-Band Graphic EQ (Low, Mid, High), Master Reverb Level, Master Volume Level.
If the signal becomes distorted, lower the channel Gain/Level. D. Using the Built-in Reverb Turn the to the 12 o'clock position. : Connect microphones via XLR or instruments/line sources
Turn down the master high EQ or lower the channel gain fader while using the Master Volume to compensate for total loudness.