Summary
Log into the router’s web interface (default IP is 192.168.1.1 , default credentials admin / blank or admin / admin ). Navigate to:
The firmware update process for the DWR-M960 involves the following steps:
: Look at the sticker under your router (e.g., H/W Ver: A1, B1, or D1). You must download firmware matching this exact version.
"D 39-Link" is a common typo or OCR error for D-Link . The correct model is the D-Link DWR-M960 . d 39-link dwr-m960 firmware
Verify this information in the web interface under or System Info after logging in. 2. Download the Correct Firmware
Log in to the router and check the "System Status" or "Firmware Information" section. Compare the version number with the one available on the D-Link support page.
Once your hardware is verified and your computer is wired to the router, follow these steps to perform the upgrade: 1. Access the Router Dashboard
Requires specific patches released after November 2025 to address critical vulnerabilities. 3. How to Update the Firmware Summary Log into the router’s web interface (default
Follow these steps for a safe upgrade from the router's web interface.
A: Extremely risky. A single packet loss corrupts the flash. Always use Ethernet.
: Firmware versions like v1.1.49 and v1.01 RevB1 (dated September 2021 or earlier) have vulnerabilities that allow attackers to download configuration files and gain administrative credentials without authentication.
Note: As of late 2025, OpenWrt also lists supported versions for this device, offering an alternative, high-performance firmware, though stock D-Link firmware is recommended for most users. Step-by-Step Guide: Upgrading DWR-M960 Firmware "D 39-Link" is a common typo or OCR error for D-Link
Do not flash a generic firmware if your router has a carrier logo (e.g., Verizon, Telcel). You will brick it.
Follow these instructions closely to update your D-Link DWR-M960 safely. 1. Download the Correct File
While updating the , you might encounter these errors: